Auto-Probe TX25A Test-Leads TA000

The Auto-probe is a kind of inductive capacitance-probe, which should be used with the oscilloscope to test the waveform as the "primary parade waveform", "secondary parade waveform" To accomplish the purpose of inspecting the ignition-system of the engine. By this method, you could see the variation of the ignition-system voltage via the time on the screen of the oscilloscope directly.
    To ensure the proper operation, please note:
    <1> The test-clip should be connected to the isolative wire of ignition plug instead of ignition plug itself to prevent the fire of electrical shock.
    <2> At least 2inchs away from other high-voltage wires to avoid the interference.
TX25A

The TA000 test lead has been custom made for automotive use with Its length (3 meters – approx 10 ft) allows the oscilloscope to be placed on the work bench away from the car being tested or repaired. A wide range of probes, clips and gators can be plugged into the 4 mm connectors at the end of the cable.
TA000

Test-Leads

Coaxial cable double-BNC
Impedance: 50Ohm
Cable length: 1m
BNC insulated: Yes
TX30

Coaxial cable BNC to Clip
Impedance: 50Ohm
Cable length: 1m
BNC insulated: Yes
TX31

Coaxial cable double - TNC
Impedance: 50Ohm
Cable length: 1m
Frequency range: DC to 3GHz
TX32

Coaxial cable double - SMA
Impedance: 50Ohm
Cable length: 1m
Frequency range: DC to 1GHz
TX33 [PDF]

TA012 2-Pin Automotive Breakout Lead

The TA012 breakout lead enables voltage readings to be taken from the numerous sensors in the engine compartment. The breakout lead is simply connected into the existing cable loom, and the output signal can then be taken from the two 4 mm automotive oscilloscope banana plugs into the using the TA000 test lead.
TA012

6-Way Universal Breakout Leads

universal 6-way breakout leads eliminate the need to own many specific breakout leads for engine diagnostics. The breakout leads are available with 3 different sizes of connectors: 1.5 mm, 2.3 mm and 2.8 mm.

The breakout lead is simply connected into the existing cable loom and enables voltage readings to be taken from the numerous sensors in the engine compartment. The output signal can then be taken from the 4 mm banana plugs into the input of the oscilloscope using the TA000 test lead.
TA024/TA025/TA026